Highland RIDGE RV, Руководство пользователя

Страница: 47 / 155

41
v
ehicle
O
peratiOn
The rear jacks con only be extended when the touch pad is in the manual mode. Once
system is in manual mode, pressing the “REAR” button will extend both rear jacks at the
same time. To extend individual rear jacks, press the “LEFT” or “RIGHT” button while
simultaneously pressing the “REAR” button, depending on which jack needs to be operated.
If the touch pad is put in the retract mode, indicated by the orange illuminated LED next to the
“RETRACT” button, the rear jacks can be retracted together by pushing the “REAR” button
or individually by pressing wither the “LEFT” or “RIGHT” buttons while simultaneously
pressing the “REAR button.
NOTE: If the rear jacks will not operate individually using the
method described above, but the operate properly when Auto Level is
performed, the Twist Prevention Protection system has locked out the
operation to prevent damage to the frame of the unit.
s
tAbilizer
J
Acks
1. Each stabilizer jack can be individually adjusted to stabilize the trailer for use.
2. When setting your RV up on soft ground, you may wish to place a wood pad or the
equivalent under each stabilizer jack foot. This will help keep the stabilizer jack from
sinking into the ground.
Manual stabilizer jacks (if so equipped)
To lower each jack, insert the jack crank onto the applicable stabilizer jack shaft.
3. To lower each jack, insert the jack crank onto the applicable stabilizer jack shaft.
4. Turn the crank clockwise to lower each leg until it contacts the ground and stabilizes
the trailer.
To raise each jack, insert the jack crank onto the applicable stabilizer jack shaft and turn the
crank counter-clockwise.
Electric stabilizer jacks (if so equipped)
Control switches for the stabilizer jacks are located on the (door) side of the unit above the
stabilizer jack(s).
To lower each jack, press the control switch until each leg contacts the ground and stabilizes
the unit.
To raise the jack, press the control switch until the jack is returned to the retracted position.
NOTE: The stabilizer jacks must be fully retracted before moving or
towing the RV to prevent stabilizer jack damage.