Highland RIDGE RV, Руководство пользователя

Страница: 68 / 155

62
S
lideOut
S
yStem
5. When the room is completely in, plug both motor connectors back into the control
module. This will apply the motor brakes for road travel.
Disengage motors, manually retract the room and travel lock
1. Locate and remove the motor retention screw which can be found near the top of each
vertical column (Fig. 3).
2. Bend back the wipe seal and visually locate the motor (Fig. 4).
3. Pull the motor up until it disengages (about 1/2 inch).
4. Repeat this process for both sides of the slide room.
5. Physically push or pull the room back into the opening, keep both sides relatively even.
6. The room must be travel locked to keep the room in place for road travel.
Error Codes
When an error code occurs during operation, the board will use the LEDs lights to indicate
where the problem is. For motor specific faults the green LED will blink (1) time for motor
#1 and (2) times for motor #2. The red LED will blink from 2 to 9 times depending on the
error code. Error codes are as follows:
2 times
Battery drop out
: battery capacity low enough to drop below 6 volts while
running.
3 times
Low battery : voltage is below 8 volts at the start of a cycle.
4 times
High battery
: voltage is greater than 18 volts.
5 times Excessive motor current : high amperage, also indicated by (1) side of the slide
continually stalling.
6 times Motor short circuit : motor or wiring to motor has shorted out.
8 times Hall signal not present : encoder is not providing a signal; usually a wiring
problem.
9 times
Hall power short to ground : power to encoder has been shorted to ground;
usually a wiring problem.
When an error code is present, the board needs to be reset. Energizing the extend / retract
switch will reset the board. Energize the extend / retract switch again to go back to normal
operation.
Refer to the Schwintek Slide Room Operation Guide for further information. Call Lippert at
(866) 524 – 7821 or visit the Lippert website at www.lci1.com for additional troubleshooting
information.
Flush Floor Slideout
For optimum performance, the slide-out system requires full battery current and voltage.
DO NOT MOVE THE RV UNLESS THE MOTORS ARE PLUGGED IN
TO THE CONTROLLER AND THERE IS BATTERY POWER TO THE RV.
THIS SETS THE BRAKES ON THE SLIDEOUTS TO PREVENT THEM
FROM MOVING DURING TRANSIT.
