Highland RIDGE RV, Руководство пользователя

Страница: 69 / 155

63
S
lideOut
S
yStem
Although the system is designed to be almost maintenance free, actuate the room once or
twice a month to keep the seals and internal moving parts lubricated. Check for any visible
signs of external damage after and before movement of the travel trailer.
Trouble shooting the flush floor slideout
If the slideout does not move when the slideout switch is depressed, follow these steps.
Check the auxiliary battery (customer supplied) for a full charge and good wire
connections.
Check the 12-volt fuse or circuit breaker.
Check for loose connections at the slideout motor.
If the slideout still will not operate, follow these steps.
If the slideout is extended, refer to the following section on overriding the specific
slideout system installed on your RV.
If the slideout is retracted, leave it in that position.
Contact your dealer or customer service for repair assistance.
If the slideout extends crooked or only one side moves, follow these steps.
Follow steps on overriding the specific slideout system installed on your RV.
You may need to push the side that is not sliding to get it to retract all the way.
Contact your dealer or customer service for repair assistance.
Manual Operation for the flush floor slideout
The electric slide comes with a manual over ride system. Locate the crank extension under
the inside of the frame (refer to Fig. 1 and 2).
This is where the crank handle (standard fifth wheel landing gear crank handle or 3/4” socket
and ratchet fits on to allow the manual extension/retraction of the room (Fig. 3 and 4).
Simply take the wrench, ratchet or drill with a nut driver and rotate it clockwise to retract
and counterclockwise to extend slide-out.
It is important to note that you DO NOT need to attempt to disengage the motor as the
actuator is “manual ready” Just hook up and crank.
Use EXTREME CAUTION when extending and/or retracting room using the manual
override feature. It is possible to operate the slideout beyond the maximum extension and/
or retraction and damage the slide components, slide room structure or trim components.
Always disconnect battery from system prior to manually operating system.
Failure to disconnect battery can cause electricity to backfeed through the
motor and cause serious damage to the system as well as void the warranty

NOTE: For long-term storage it is recommend the room be closed
(retracted).