Highland RIDGE RV, Руководство пользователя

Страница: 114 / 155

108
p
lumping
S
yStem
Lingering Chlorine Taste:
If a chlorine taste lingers in the water, flush the water system with a solution consisting
of one-quart vinegar to five gallons of clean water. Re-flush as necessary. The vinegar
solution may damage the water heater so it must be bypassed again before performing
this operation.
1. Drain the fresh water system by opening all faucets, low point drains and opening the
fresh water tank drain valve.
2. Water heater power should be OFF (both switches: electric and LP gas). Water heater
gas valve should be OFF (located outside the RV).
3. Bypass the water heater. Valve 4 OFF, valve 5 ON.
4. Set the water valves to the sanitize:
Valve 1 pointing towards the water pump
Valve 2 pointing towards valve 3.
Valve 3 ON.
5. Turn the water pump ON at the command center. Vinegar solution will be siphoned into
the water tank. Fixtures in the RV should be OFF.
6. After vinegar solution is in the water tank, return the water valves to their normal
positions (refer to Step 21).
7. Finish filling the fresh water tank by attaching a hose from a pressurized water source
to the fresh water connection inlet at the utility center. When finished filling the tank,
turn off the water supply and disconnect the hose.
8. Water valves should still be in the normal position, turn the water pump ON.
9. Run water through all faucets (hot and cold, including outside shower) until chlorine
smell is gone.
10. Close all faucets including outside shower. Turn pump OFF.
11. Drain the fresh water system by opening all faucets and low point drains, and by
opening the fresh water tank drain valve.
12. Close low point drains and fresh water tank drain. Set water valves to their normal
position (refer to Step 21).
13. Refill the fresh water tank with fresh water. Use the fresh water connection inlet on
the outside of the RV. Attach a hose to the fresh water connection inlet, the other end
of the hose to a pressurized water source. Turn the water source ON and fill the tank.
14. When tank is full, turn water source OFF and disconnect the hose.
15. Turn the water pump ON, and open faucets and check that the chlorine taste is gone.
16. Drain the system one more time and refill the tank with fresh water.
17. When water heater is full of water turn the gas valve ON, and then turn the water heater
power ON.