viii
Cyberlight
User Manual
Table of Figures
Figure 1-1. Identifying Cyberlight rear panel components. ...................................... 1-8
Figure 1-2. View of the bottom of the Cyberlight fixture, where the access door
latches are located............................................................................... 1-11
Figure 1-3. Removing the first four rear panel screws in order to access
the Cyberlight voltage selection jumpers. .......................................... 1-12
Figure 1-4. In order to remove the lamp box access door, you need to remove
the last two 5/32 inch allen screws, which are located by the
color mixing and dim flags. ................................................................ 1-12
Figure 1-5. On CL and CX models, make sure you disconnect the fan
power wires from the fan connectors before removing the
lamp box access door. ......................................................................... 1-13
Figure 1-6. Location of the voltage selection jumpers and the voltage
selection wire. ..................................................................................... 1-13
Figure 1-7. Location of the voltage selection tabs and connector. ......................... 1-13
Figure 1-8. Components of the Cyberlight yoke. ................................................... 1-14
Figure 1-9. Installing the yoke on the Cyberlight fixture. ...................................... 1-15
Figure 1-10. Location of lamp assembly and optimization screws. ....................... 1-16
Figure 1-11. Removing the lamp from its socket. .................................................. 1-17
Figure 1-12. Installing the new lamp into the socket. ............................................. 1-17
Figure 1-13. Placing Cyberlight fixture in setup mode allows you to
perform the necessary lamp optimization prior to using a
newly-installed lamp. ......................................................................... 1-18
Figure 1-14. Removing the center access door. ...................................................... 1-20
Figure 1-15. The color wheel is located between the effects wheel and the
color mixing flags, opposite the rotating litho wheel. ........................ 1-20
Figure 1-16. High End Systems recommends you replace the CL color
correction filter (at position 4) with the salmon-colored
CTO correction filter, and the aqua filter (at position 5)
with the homogenizing frost filter. ..................................................... 1-21
Figure 1-17. Push the dichroic filter toward the large retaining tab to free
it from the wheel clips. ....................................................................... 1-21
Figure 1-18. Orient the coated side of the dichroic toward the lamp and the
uncoated side toward the static litho wheel. ....................................... 1-22
Figure 1-19. The personality switches. ................................................................... 1-22
Figure 1-20. The Cyberlight rear panel LEDs give you information about
the Cyberlight fixture’s lamp, fixture voltage, operating
temperature, data transmission and reception, and other factors. ....... 1-24
Figure 1-21. Setting the Cyberlight power switch to the ON and OFF positions. .. 1-29
Figure 2-1. The address switch block allows you to select the control protocol
(DMX 1, DMX 2, DMX 3, or LWR) and the fixture number. ............. 2-4
Figure 2-2. Properly-constructed data cable. ........................................................... 2-6
Figure 2-3. Constructing a data cable terminator. ................................................... 2-7
Содержание Cyberlight
Страница 123: ...C 8 Cyberlight User Manual...
