High End Systems Cyberlight, Руководство пользователя

Страница: 10 / 147

C yberlight User Manual ix
Figure 2-4. Make sure you connect the Data Out connector from the
previous Cyberlight to the Data In connector of the next
Cyberlight. Also, you must terminate the Data Out connector
of the last device in the link (whether the last device is a
Cyberlight or something else). .............................................................. 2-8
Figure 2-5. Attaching two C-clamps to the Cyberlight yoke. ................................ 2-11
Figure 2-6. Always use suitable safety cables when hanging a Cyberlight
from a truss or any other support system. The safety cable can
be looped around the support and the Cyberlight yoke once or
twice; loop it twice if this will help prevent the fixture from
rotating, thus possibly loosening the clamp mounting bolt. ............... 2-11
Figure 2-7. Loosening the hub screws allows you to adjust the wheel’s
clearance. ............................................................................................ 2-18
Figure 2-8. Loosen these two allen screws to adjust the rotating litho wheel. ...... 2-19
Figure 2-9. The rotating litho wheel’s spring plunger must always contact
the rotating litho wheel. ....................................................................... 2-19
Figure 3-1. Holding the fan fins in place while you clean the fans using
compressed air. ..................................................................................... 3-3
Figure 3-1. Bottom view of the Cyberlight fixture. .................................................. 3-4
Figure 3-2. Locations of the iris, power lens, focusing lens, zoom lens and
mirror. ................................................................................................... 3-5
Figure 3-3. Locations of the Cyberlight motors. ....................................................... 3-5
Figure 3-4. Close the iris by rotating the large black gear located on top of the
iris motor. .............................................................................................. 3-6
Figure 3-5. Cleaning the anti-reflective glass. .......................................................... 3-6
Figure 3-6. Removing the standoff between the iris motor and the
color wheel. ........................................................................................... 3-7
Figure 3-7. Make sure the wheel is positioned with the keyhole slots
facing downward before removing it. ................................................... 3-7
Figure 3-8. The homing slot is a small groove on the outside edge of
the wheel. The static litho wheel and the color wheel’s homing
slots are in different locations. The effects wheel does not have a
homing slot. .......................................................................................... 3-8
Figure 3-9. Clean the groove in the wheel sensor. .................................................... 3-8
Figure 3-10. Static litho wheel lithos must be oriented with the
coated/etched side facing away from the lamp. .................................... 3-9
Figure 3-11. Color wheel dichroic filters should be oriented with the coated
side of the dichroic facing toward the lamp and the glass side
facing toward the static litho wheel. ..................................................... 3-9
Figure 3-12. Position the keyhole slots so they fit over both hex screws as
well as the “slider” screw inset in the hub. ......................................... 3-10
Figure 3-13. Location of lamp assembly and optimization screws. ........................ 3-11
Figure 3-14. Removing the lamp from its brass socket. ......................................... 3-11