User manual - Machine Automation Solution - V3R003
49 / 102
.
Figure - Realign
Two different behaviors are possible when selecting this option, it is necessary to previously configure the default behavior
as described below.
To define the behavior of the realignment option, proceed as follows:
1. Select the
Guidance
option in the
Configuration Menu
;
2. Select the option
Guidance settings
;
3. Select the default option in the middle frame.
Figure - Guidance settings
The following behavior options are available:
·
Move the guide position by moving the GNSS position
This option is selected by default. In this option when the
Realign
button is clicked on the operation screen,
the equipment adjusts the position of the GNSS of the guide to the current position where the vehicle / antenna
is located, thereby moving the guide to the zero error position.
Important
In this option, as the positions of the guides are changed, it is not possible to return the
position of the original guide. If you intend to work again in the area already applied using the
same guides, it is advisable to use the other behavior that would be to realign by moving the
position of the guide.
·
Move the position of the guide by creating a new guide
When the user selects this behavior, when selecting the
Realign
button on the operation screen, the
equipment will draw a new original guide similar to the previous one in the same location where the vehicle /
antenna is located and new parallels will be drawn. The previous original guide can be accessed again in the
guide manager, if it has been saved.
Important
In this option, the visual result for the user is the same as the previous option, the movement
of the guide aligned to the vehicle, but here in fact a new guide was created.
11.1.2.3 Manual adjustment mode
The
Manual adjustment
option is presented on the operation screen, when working with an active guide, see the topic
.
