Hexagon AgrOn Ti10, Руководство пользователя

Страница: 100 / 102

User manual - Machine Automation Solution - V3R003 100 / 102
18. Problems and solutions
Problem Solution
Display will not turn on
Check the power supply;
Check the fuse;
Check if the connections are secure;
Check if the cable is not broken (use a multimeter to test the voltage).
GNSS problem
Check if the GNSS is in an area with sky-bound view. In covered areas, the signal will
become too low and may note locate properly;
Check the antenna cabling;
Measure the GNSS cable voltage (5v);
Check if the GNSS Port and Model are correctly selected on the GNSS menu.
Motor will not move
Perform display tests and calibrations;
Check if the hose connections are correct (pressure and tank);
Check if the command is in the right direction;
Check if the operation is not stopped in the display;
Check if the encoder is blinking when it turns;
Check if the vehicle is not below the operation speed range.
Map problems
Within the pendrive, the SHP, SHX, and DBF files must be in the same location;
The ma name cannot contain special characters or spaces;
The map name might be too long.
Sprayer problems
Perform calibration and simulation;
Check the filter;
Check the valve and flow meter cabling;
Check if the vehicle is below the operation speed range.
Application failure when
entering and exiting
borders
Check if the antenna-pin and pin-implement distances are correct.
Nothing happens after
starting the installation
test for the pilot sensor
Check if the automatic pilot driver is recognized on the network (Settings menu
– Network
diagnosis). In case it is not found, check the power supply and cable continuity;
Check the sensorʼs power cable for continuity and check that the voltage between pins “3”
and
“1” is of 12v.
Nothing happens after
starting the HV control
test
Check if the automatic pilot driver is recognized on the network (Configuration menu
–
Network diagnosis).
In case it is not found, check the power supply and cable continuity;
Check the wheel sensor and hydraulic valve cables;
Check the hydraulic system (if there are no inverted connections, etc).
The wheel turned to the
opposite side Invert the connectors on the valve terminals. If the problem persists, check the instructions
on the hydraulic pilot topic Sensor installation.
Pilot problems
Check the tank oil level;
Check for possible leaks;
Check the pilot diverʼs attachment;
Check the steering sensor.