HB-THERM HB-TP180, Инструкция по эксплуатации

Страница: 45 / 48

HB-TP180/200 Checking Facility for Temperature Control Units
Maintenance
O8354-EN 2018-11 45
8.2 Maintenance schedule
The next paragraphs describe the maintenance work necessary for
optimum and trouble-free operation.
If, during regular checks, increased wear is detected, then the
required maintenance intervals are to be reduced corresponding to
the actual signs of wear.
For questions concerning maintenance work and intervals, please
contact the HB-THERM representative (

www.hb-therm.ch ).
Interval Assembly / Component Maintenance work Carried out
by
quarterly Seals Check for damage Specialist
Replace if necessary Specialist
Every 2 years Hydraulic hoses
(HB-TP180-45)
1)
Check for damage on outer sheath and in
the sealing area Hydraulic
specialist
Replace if necessary Hydraulic
specialist
Checking facility Carry out the quality test (pressure,
temperature and flow rate) HB-Therm/CH
1) The maintenance of external hoses is to be carried out according to the manufacturer's instructions.
8.3 Maintenance tasks
8.3.1 Cleaning
CAUTION!
Risk of burns due to hot surfaces!
Contact with hot parts can cause burns.
Therefore:
– Wait for the unit to cool down, depressurise it
and switch it off.
– Before carrying out any work, ensure that all
parts have cooled down to ambient
temperature.
Clean the unit under the following conditions:

Only clean the outer parts of the unit with a soft, moist cloth.

Do not use any aggressive cleaning agents.