11. Screw the rod end onto the thread of the piston rod as far as
it will go.
12. Using the open-end wrench (2) and torque wrench (1), tighten
the rod end to the required torque according to the technical
drawing.
Wrench size 22 (2); wrench size 24 (1)
13. After tightening to torque, mark the nut and rod eye with
threadlocker paint.
14. After 24 hours setting time, the hydraulic locking unit can be
reused, and put into operation on the ride (chapter
up the hydraulic locking unit", page 26
HAWE Hydraulik SE
B 6052-21 -
11
-2021 - 1.7
43/63
