Aids, tools, materials
■
Replacement rod end according to the technical data specifications
■
Hot air gun
■
When replacing on a HLU-LE-X (M):
- Open-end wrench, sizes 22 and 24 mm
- Torque wrench with fork size 24 mm
- Torques according to technical drawing
■
Degreaser, threadlocking adhesive, brass brush and lint-free cloth according to the recommended
cleaning and care products on page (
1. Shut down hydraulic locking unit and secure it against inadvertent restarting.
2. Remove the hydraulic locking unit from the ride.
3. Clamp the hydraulic locking unit in a vise so that the rod end is easily accessible.
Use jaw caps.
Be careful not to damage the connection block.
4. Remove the red rubber cap to gain access to the emergency
override mechanism.
5. Fully extend the piston rod (2) by tripping the emergency
override (1).
Observe the procedure detailed in chapter 6
power supply disconnected", page 29
.
6. Heat the marked area (1) of the rod end to 200°C with a hot
air gun (2).
The threadlocker loses its adhesive properties.
HAWE Hydraulik SE
B 6052-21 -
11
-2021 - 1.7
41/63
