Haulotte Group HTL 3210, Руководство оператора

Страница: 218 / 248

218 2420344510 E 11.11 AUS
Telescopic handlers
H
- Lubrication and maintenance
16.1.2 - Draining the rear axle
Capacity :
• Differential : 10 l(2,64 gal US)
• Before performing the oil replacement operations, firstly remove the drain plugs ( 2 ) to eliminate any
pressure from inside the housing.
• Loosen the drain plug ( 4 ) and let the oil drain out.
• Refit and tighten the drain out ( 4 ).
• Loosen the control plug ( 1 ).
• Fill the axle with oil to the level of the control plug ( 1 ).
• Refit the control plugs ( 1 ) and the drain plugs ( 2 ).
Section H 20.3 -Refer to the Lubricants and equivalents table for the type of oil used.
16.1.3 - Draining the epicycloidal reducers
N.B. -:-To replace the reducer oil, you must move the machine to position the closure plug in the required
positions. Due to the presence of a differential on each of the axles, you will have to repeat this operation
for each of the machine wheels.
Capacity : 4 x 1,3 l(4 x 0,34 gal US).
• When it is in the high position, loosen the plug ( 3 ) by a few turns, to release any internal pressure
from the housing and then close it again.
• Drive the machine slowly to bring the plug to its low position.
• Loosen the plug completely and let the oil drain out.
• Drive the machine slowly to bring the plug to horizontal position.
• Fill the reducer; the oil level must be level with the plug.
• Refit the plug ( 3 ).
Section H 20.3 -Refer to the Lubricants and equivalents table for the type of oil used.