Installing Spectrum X components
What to do next
Ensure that the following guidelines are met before operating the device in the rack:
• The ambient temperature around the unit (which may be higher than room temperature) is within the
limit specified for the unit.
• There is sufficient airflow around the unit.
• Electrical circuits are not overloaded; consider the nameplate rating of all the connected equipment.
• There is over-current protection.
• The equipment is properly grounded.
• No objects are placed directly on top of the unit.
Installing Spectrum X components
Install Spectrum X power supplies and drives before connecting the system.
Installing the Spectrum X bezel
Align the bezel in front of the chassis so that the Harmonic logo appears on the top left corner.
CAUTION:
The front panel on the Spectrum server is susceptible to electrostatic discharge
(ESD) when the bezel is removed. Wear the appropriate ESD protection when you remove
the bezel.
1. Connect the USB cable inside the bezel to the right-hand USB port on the front panel. (The other USB
port is covered.)
2. Keeping the corners aligned, press the bezel straight onto the chassis. The USB cable will form a loop
that fits inside the metal panel of the bezel.
3. Hand-tighten the two captive thumb screws to secure the bezel in place.
NOTE:
After installing the bezel, it may take up to 30 seconds for the front panel LEDs
to return to their previous state.
35
Spectrum System 8.4 Installation Guide
