HANGCHA XF Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 45 / 142

41
Rear wheel
①
Park forklift trucks on level concrete.
②
Pull the parking brake lever and place
chocks before front wheels to prevent
movement of forklift.
③
Put the lifting jack under the
counterweight.
Caution
：
Make sure the jack capacity
is greater than 2/3 of service weight of
forklift.
④
Loosen wheel nuts 1-2 turns by
turning them counter-clockwise.
Warning
Do not remove wheel nuts until rear tires
are raised from ground.
⑤
Raise the forklift with jack until rear
wheels off the ground. Support forklift
truck by putting additional wooden
blocks under both sides of the front truck
frame as shown below.
⑥
Take out the wheel nut of rear wheel,
and then replace the wheel.
Warning
a.
When removing tire from wheel rim,
do not remove rim set bots and nuts before
releasing air;
b. Make sure that wooden blocks
used to support lift truck are solid,
one-piece units;
c. Never get under forklift while it is
supported only by wooden blocks.
⑦
Retighten nuts as shown in figure
below.
⑧
Remove the wooden block under
chassis body. Let down the forklift slowly.
Then take away the chocks and jack
from the rear part of the front wheel.
⑨
Retighten the wheel nut with the
correct torque. Please refer to
Tightening Torque Table .
⑩
Adjust tire pressure to specified value.