HANGCHA XF Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 38 / 142

34
3.Monthly maintenance
（
166hours
）
Increase the below content based upon
weekly maintenance
1. Change engine oil and oil filter
（
only for
the first time, then per 500hours
）
①
Start the engine, warm-up enough,
then shut off.
②
Remove oil cover and bottom shell to
plug, release the oil.
Warning
Be careful with the hot oil.
Milky oil shows there is some cooling
fluid in it, find out the reason and correct.
Thin oil shows that the oil contains
gasoline.
③
Wipe up and fit drain plug and
gasket. Tightening torque of drain plug
：
29
～
39 N·m
④
Dismantle the oil filter by tool.
⑤
Use cloth to clean the surface of oil
filter.
⑥
Lay on little oil on the rubber ring of
new oil filter.
⑦
Install new oil filter by hand, not
spanner.
⑧
Reference Table for the oil used in the
truck , oil preferred
⑨
Start the engine, check for oil leaks
around drain plug and filter.
If the leak is excessive, the part has not been
installed correctly.
⑩
Warm-up engine, then shut-off and
check oil level, fill if needed.
To check the oil fluid level, place truck on
level ground.
2. Apply lubricate to front and rear of pin
roll of tilt cylinder
Clean the area, and remove used oil.
3. Check the gear oil of drive axle housing
Change the oil after 200 hours if operating
truck in dusty environment.
4. Change transmission oil filter (first
time, then semiannually)
Check the hydraulic transmission oil fluid, if
more dust, change the hydraulic oil of
transmission. Change only for the first time.
①
Park the truck on level ground,
lay-down the fork to the floor, incline the mast
back, apply parking brake, put transmission in
neutral position, shut off engine.
Warning
Hot hydraulic oil and parts will cause injury.
DO NOT touch the hot hydraulic oil and
parts.
②
Dismantle rubber mat and front
soleplate.
③
Dismantle filter and deal with local
regulation.
④
Clean pedestal of filter, confirm that
the old gasket of pedestal is clean.
⑤
Apply small amount hydraulic oil on
the new filter gasket.
⑥
Install filter by hand. When the filter get
to pedestal, screw down an additional 1/2-3/4
turn.
5. Change hydraulic transmission oil (first
time, then semiannually)
Park truck on level ground, lay-down the fork
to the floor, incline the mast back, apply
parking brake, put transmission in neutral