Haas TL Series, Руководство по обучению

Страница: 98 / 111

ES0609 rev D 4/09
36
IpS r
ecorder
The IPS recorder provides a simple method to place G-code generated by IPS into new or existing programs.
1. To access IPS, press MDI/DNC, then PROGRM/CONVRS. Refer to your Intuitive Programming System
Operator Manual (ES0609 Lathe) for more information on using IPS.
2. When the recorder is available, a message appears in red in the lower right corner of the tab:
VQC GROOVING THREADING DRILL & TAP MANUAL CHAMFER AND RADIUS
TOOL NUMBER
WORK OFFSET
Z START PT
DIA TO CUT
Z DIMENSION
DEPTH OF CUT
MAX RPM
SFM
1 1000
54 0.0000 in 200
0.0000 in 0.0500 in
RAPID
Press <CYCLE START>
to run in MDI or <F4>
to record output to a
program.
SETUP TURN & FACE
FILLET RADII
0.0000 in
OUTSIDE DIA. FEED PER REV
0.0000 in 0.0100 in
TOOL NOSE
0.0315 in
0.0000 in
FEED OD TURN ID TURN FACE PROFILE
3. Press F4 to access the IPS recorder menu. Choose menu option 1 or 2 to continue, or option 3 to cancel
and return to IPS. F4 can also be used to return to IPS from any point within IPS recorder.
IPS Recorder Menu
Menu Option 1: Select / Create Program
Select this menu option to choose an existing program in memory or to create a new program into which the
G-code will be inserted.
1. To create a new program, input the letter ‘O’ followed by the desired program number and press the
WRITE key. The new program is created, selected, and displayed. Press the WRITE key once more to insert
the IPS G-code into the new program.
2. To select an existing program, enter an existing program number using the O format (Onnnnn), then press
the WRITE key to select and open the program. To choose from a list of existing programs, press the WRITE
key without input. Use the cursor arrow keys to choose a program and press WRITE to open it.