Haas TL Series, Руководство по обучению

Страница: 68 / 111

ES0609 rev D 4/09
6
Retract Dist – The distance from the Hold Point (Setting 107) the tail stock will retract when commanded.
This setting should be a positive value. Press Write to add F1 to set or Part Zero Set to record current
position. Enter a value and either press Write to add the value to the current value, or F1 to replace the value
with the entered value. Press Part Zero Set to record the Z Offset current position.
Advance Dist – When the tail stock is moving toward the Hold Point (Setting 107), this is the point where it
will stop its rapid movement and begin a feed. This setting should be a positive value. Press the Up and Down
arrows to change the displayed Work Zero Offset.
X Clearance – Works with Z Clearance to define a tail stock travel restriction zone that limits interaction
between the tail stock and the tool turret. It determines the X-axis travel limit when the difference between
the Z-axis location and the tail stock location falls below the value in Z Clearance. If this condition occurs
and a program is running, an alarm is generated. When jogging, no alarm is generated, but travel is limited.
Press Write to add or F1 to set position. Enter a value and either press Write to add the value to the current
value, or F1 to replace the value with the entered value. When highlighting X CLEARANCE, pressing X DIA
MEAS takes the value of the X axis and places it in X CLEARANCE. Pressing ORIGIN when highlighting X
CLEARANCE sets clearance to max travel.
Z Clearance – Minimum allowable difference between the Z-axis and the tail stock. A value of -1.0000 means
that when the X-axis is below the X clearance plane, the Z-axis must be more than 1 inch away from the tail
stock position in the Z-axis negative direction. The default value for this setting is zero. Press Write to add F1
to set or Part Zero Set to record current position. Enter a value and either press Write to add the value to the
current value, or F1 to replace the value with the entered value. Press Part Zero Set to record the Z Offset
current position. When highlighting Z CLEARANCE, pressing Z FACE MEAS takes the value of the Z axis and
places it in Z CLEARANCE. Pressing ORIGIN when highlighting Z CLEARANCE sets clearance to zero.
a
utoMatIc
M
ode
On each of the following interactive screens, the user is asked to enter data needed to complete common
machining tasks. When all data has been entered, press “Cycle Start” to begin the machining process.
The following are examples of the types of the Automatic Mode screens and the definitions of the variables
that will need to be entered.
Turn and Face - Rapid
This mode is for making a rapid move.
GROOVING THREAD RE-CUT THREADING DRILL & TAP CHAMFER & RADIUS MANUALSETUP
RAPID FEED OD TURN FACE
TURN & FACE
ID TURN PROFILE
TOOL NUMBER
1
WORK OFFSET
54
X POSITION
0.0000 in
Z POSITION
0.0000 in
Press <CYCLE START> to run
in MDI or <F4> to record
output to a program
Tool Number – Enter the tool to be used.
Work Offset – Enter the work offset to be used.
X Position
– Enter end point or move tool to end point desired. Press X DIA. MEAS to record this position.