Haas TL Series, Руководство по обучению

Страница: 78 / 111

ES0609 rev D 4/09
16
Scroll Right - Allows you to scroll the view window to the right.
Scroll Left - Allows you to scroll the view window to the left.
Exit Zoom - Turns off the zoom and scrolling function.
Enter Data Into Table - Transfers data from command line into selected data box or accepts value jogged.
Insert Line Into Table - Moves selected line down and inserts new line into table. Will not work if table is full!
Clear All Data In Table - Clears all the data in current table and puts the table in its home position.
Go To X Axis Data Box - Highlights X axis data box and changes drawing cursor to only move in X direction.
Go To Z Axis Data Box - Highlights Z axis data box and changes drawing cursor to only move in Z direction.
Move Up To Next Data Box - Moves up to next data box above its current location. Will not move if already
at the top of the table.
Move Down To Next Data Box - Moves down to next data box below its current location. Will not move if
already at the bottom of the table.
Move Right To Next Data Box - Moves to the next data box to the right of its current location. Will wrap if
already at the far right.
Move Left To Next Data Box - Moves to the next data box to the left of its current location. Will wrap if
already at the far left.
Chamfer & Radius - OD Radius
This mode is used to cut an outside diameter radius.
GROOVING THREAD RE-CUT THREADING DRILL & TAP MANUALSETUP TURN & FACE
Press <CYCLE START> to run
in MDI or <F4> to record
output to a program
TOOL NUMBER
1
WORK OFFSET
54
Z START PT
0.0000 in
OUTSIDE DIA.
0.0000 in
OD RADIUS ID RADIUS OD CHAMFER ID CHAMFER
RADIUS
0.0000 in
0.0500 in
0.0060 in
MAX RPM
1000
SFM
200
DEPTH OF CUT
FEED PER REV
TOOL NOSE
0.0310 in
CHAMFER & RADIUS
Tool Number – Enter the tool to be used.
Work Offset – Enter the work offset to be used.
Z Start PT – Enter the Z axis starting point.
Outside Dia. – Enter the current diameter of the work piece. Manually measure the diameter.