26
Figure 21 Selecting hosts for the storage cluster
7.
Click the icon for a host.
8.
Configure the following settings:
{
NIC Template
—Select whether to apply physical interface settings on the host to other
hosts. For this feature to take effect, make sure the other hosts have active physical
interfaces of the same names as those on this host and the interface speeds are as required.
If a host cannot meet the requirements, you must configure physical interface settings for
the host manually.
{
IP Address
—Specify a management IP address for the node. The management IP address
of the management node is the specified start IP address on the
Network
page and cannot
be modified. If you do not specify a management IP address for a storage or monitor node,
the system assigns an available IP next to the start IP with an increment of 1 to the host. You
do not need to specify a service network IP for a host.
Figure 22 Customizing configuration for a host
9.
Click the
icon for the management network (required) and service network to specify a
physical interface for them, and then click
OK
.
10.
Configure the following parameters and then click
OK
:
{
LAGG Mode
—Select the aggregation mode of physical NICs in the management network.
Options include
Static
and
Dynamic
. The physical switch must be enabled with LACP if the