H3C MSR810, Справочник по командам

Страница: 309 / 389

297
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] dialer queue-length 10
dialer route
Use
dialer route
to configure a dialup interface to place calls to a remote site or receive calls from it.
Use
undo dialer route
to remove the configuration.
Syntax
dialer route ip next-hop-address
[
mask network-mask-length
]
[
vpn-instance vpn-instance-name
] [
dial-number number
[
autodial
|
interface interface-type
interface-number
] * ] [
broadcast
|
user hostname
] *
undo dialer route protocol next-hop-address
[
mask network-mask-length
]
[
vpn-instance vpn-instance-name
] [
dial-number number
]
Default
No dial string is configured.
Views
Dialup interface view
Predefined user roles
network-admin
Parameters
ip
: Specifies IP as the network layer protocol.
next-hop-address
: Specifies the IP address of the remote site.
mask network-mask-length
: Specifies a mask length for the remote IP address, in the range of 0 to
32. If no mask length is specified, a 32-bit mask applies. Setting the
next-hop-address
argument to
0.0.0.0 and the
network-mask-length
argument to 0 indicates any remote IP address.
vpn-instance vpn-instance-name
: Specifies an MPLS L3VPN instance by its name, a
case-sensitive string of 1 to 31 characters.
dial-number number
: Specifies the dial string for calling the remote site, a case-insensitive string of
1 to 30 characters. If no dial string is specified, the interface can only receive calls.
autodial
: Enables the interface to automatically dial the specified dial string at specified intervals.
The interval is set in the
dialer timer autodial
command and defaults to 300 seconds.
interface interface-type interface-number
: Specifies a physical interface by its type and number.
When multiple physical interfaces are assigned to a dialer interface and t heir dialup links are
connected to different SPCSs, you must associate each dial string with one physical interface. This
configuration is intended for dialer interfaces in traditional DDR only.
broadcast
: Enables broadcast packets to pass through the dialup link.
user hostname
: Specifies a host name of the remote device, a case-insensitive string of 1 to 80
characters used to authenticate incoming calls.
Usage guidelines
To enable DDR to originate calls, you must configure the
dial-number number
option. Otherwise,
DDR can only receive calls.
If you specify the
number
argument in the
dialer route
command, you must also include the
number
argument when using the
undo dialer route
command to remove the dial string.