H3C MSR810, Справочник по командам, Страница: 113 / 389

101
Field Description
Last 300 seconds input rate: 0 bytes/sec, 0
bits/sec, 0 packets/sec
Average rate of inbound traffic in the last 300 seconds.
Last 300 seconds output rate: 0 bytes/sec,
0 bits/sec, 0 packets/sec
Average rate of outbound traffic in the last 300 seconds.
Input: 154 packets, 1880 bytes, 0 drops
Total number of inbound packets, total number of inbound
bytes, and total number of dropped inbound packets.
Output: 155 packets, 1875 bytes, 0 drops Total number of outbound packets, total number of outbound
bytes, and total number of dropped outbound packets.
# Display summary information about Virtual-PPP 10.
<Sysname> display interface virtual-ppp 10 brief
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Primary IP Description
VPPP10 ADM DOWN 10.0.0.1 Virtual-PPP10 Interface
# Display information about the virtual PPP interfaces in physically down state and the causes.
<Sysname> display interface virtual-ppp brief down
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
VPPP9 ADM Administratively
VPPP10 ADM Administratively
VPPP12 ADM Administratively
# Display summary information about Virtual-PPP 10, including the complete interface description.
<Sysname> display inter Virtual-PPP 10 brief description
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Primary IP Description
VPPP10 ADM DOWN 10.0.0.1 Virtual-PPP10 Interface
Table 18 Command output
Field Description
The brief information of
interface(s) under route
mode/Brief information on
interfaces in route mode
Summary information about Layer 3 interfaces.
Link: ADM - administratively
down; Stby - standby
Link status:
•
ADM
—The interface has been shut down by the network
administrator. To recover its physical layer state, execute the
undo
shutdown
command.
•
Stby
—The interface is a backup interface. To see the primary
interface, use the
display interface-backup state
command
described in
High Availability Command Reference
.