H3C MSR810, Справочник по командам

Страница: 354 / 389

342
Views
Interface view
Predefined user roles
network-admin
Parameters
dlci-number
: Specifies a VC by its DLCI number in the range of 16 to 1007. If you do not specify a
VC, all VCs on the interface and on all its subinterfaces are specified.
Usage guidelines
IND automatically creates IPv6 address-to-DLCI maps on an interface.
If you enable or disable IND on a Frame Relay interface without specifying a VC, IND is enabled or
disabled on the following VCs:
• All VCs on the Frame Relay interface.
• All VCs on each subinterface of the Frame Relay interface.
Examples
# Enable IND for all VCs on interface Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] fr ipv6 ind
fr lmi n391dte
Use
fr lmi n391dte
to set the DTE-side N391 counter.
Use
undo fr lmi n391dte
to restore the default.
Syntax
fr lmi n391dte n391-value
undo fr lmi n391dte
Default
The DTE-side N391 counter is 6.
Views
Interface view
Predefined user roles
network-admin
Parameters
n391-value
: Sets the DTE-side N391 counter in the range of 1 to 255.
Usage guidelines
This command is available on DTE interfaces.
A DTE sends status enquiry messages at an interval set by the T391 timer to a DCE. The status
enquiry messages include link integrity verification enquiry messages and full status enquiry
messages. The ratio of sent link integrity verification enquiry messages to sent full status enquiry
messages is (N391–1):1.
Examples
# Set the type of Frame Relay interface Serial 2/1/0 to DTE. Set the N391 counter to 10.