GSK 980TC3 Series, Руководство пользователя

Страница: 211 / 226

Appendix 1 Servo Tool Post Explanation
199
Appendix
0 Y3.0
NC signal output s
the driver DI1
Corresponding to the servo driver CN1
interface’s pin 9 tool number selection
1 Y3.1
NC signal output s
the driver DI2
Corresponding to the servo driver CN1
interface’s pin 10 tool number selection
2 Y3.2
NC signal output s
the driver DI3
Corresponding to the servo driver CN1
interface’s pin 34 tool number selection
3 Y3.3
NC signal output s
the driver DI4
Corresponding to the servo driver CN1
interface’s pin 8 tool number selection
4 Y3.4
The tool post
locking signal
Tool post lock output signal
5 Y3.5
The tool post
releasing signal
Tool post release output signal
6 Y3.6
Mode switch input
MD0
Corresponding to the servo driver CN1
interface’s pin 31 D17 signal
GL200(Y3)
7 Y3.7
Mode switch input
MD1
Corresponding to the servo driver CN1
interface’s pin 30 D18 signal
④
The ladder’s relevant parameters
No.
Setting
value
Definition Remark
K01.0 1
Whether to use the tool
post
K2.0/1
K2.0=1
K2.1=0
Tool post selection Select the servo tool post
K09.0 1
Whether to use the
hydraulic device
980TC3 simultaneously sets K9.1 to 1
，
and directly
starts the hydraulic instead of opening the
parameter
K12.0 0
Whether the tool post
releasing/clamping signal
switch is normally closed
Set it according to the tool post switch state
K12.1 0
The tool releasing/
clamping uses one input
interface
Set it according to the tool post switch state
T038 5000
The tool post clamping
delay check
The system has not received X2.6 in-position signal
in the range after the clamping signal sends, A5.2
alarm occurs
T039 5000
The tool post releasing
delay check
The system has not received X2.6/X3.5 in-position
signal in the range after the releasing signal sends,
A5.3 alarm occurs
T040 10000
The servo is ready to
delay the check time
The system has not checked the servo ready signal
and A5.0 alarm occurs
T041 10000
The tool post zero return
to delay the check time
The zero return is not completed in the range, and
A5.4 alarm occurs
T042 10000
Tool selection controls the
delay check
The tool change is not completed in the range set
by the parameter, and A5.4 alarm occurs
T043 100
The tool post clamps the
delay completion Delay to execute the next step after the servo
receives the locking signal
T044 100
The tool post releases the
delay completion Delay to execute the next step after the servo
receives the releasing signal
T045 1000
Delay the tool post servo
alarm
An alarm A6.0 occurs when the servo alarm signal
length exceeds the range