GSK 980TC3 Series, Руководство пользователя, Страница: 196 / 226

GSK980TC3 Series Bus Turning CNC system PLC, Installation and Connection User Manual
184
Inst
allation
and
Connection
Ⅳ
X6.3=the spindle zero-speed check signal
；
X6.5=speed/position switch completion; X6.6=the spindle
orientation completion.
Data parameterNo.258
2 5 8 The spindle speed upper limit
Data parameterNo.286
～
No.288
2 8 6 Gear’s tooth quantity at the side of the spindle (No. 1 gear)
2 8 7 Gear’s tooth quantity at the side of the spindle (No. 2 gear)
2 8 8 Gear’s tooth quantity at the side of the spindle (No. 3 gear)
Data parameterNo.290 ～ No.292
2 9 0 Gear’s tooth quantity at the side of the position encoder (No. 1 gear)
2 9 1 Gear’s tooth quantity at the side of the position encoder (No. 2 gear)
2 9 2 Gear’s tooth quantity at the side of the position encoder (No. 3 gear)
z Operation sequence
The spindle operation sequence is shown in Fig.4-9-1
：
Fig. 4-9-1 Sequence of the spindle rotation CCW
z
Control logic
①
When the system is turned on, the spindle stops, M05 signal output remains;
①
After M3/M4 is executed, M3/M4 is valid and remains and M05 signal closes output;
4.10 The Spindle Gear Change Control
z Relative signals
X2.0
～
X2.1: The spindle gear change in-position signal.
When the spindle frequency conversion (0~10V analog voltage output) controls, the system can
support the spindle automatic gear change control with three gears and the gear change
in-position detection function with three gears.
z Signal diagnosis
System diagnosis （ input state at side of the machine ）
State
address
X2.4 X2.3 X2.1 X2.0
Pin
GL200
(X2.3)
GL200
(X2.2)
GL200
(X2.1) GL200
(X2.0)
X2.0=the spindle No. 1 gear in-position; X2.1= the spindle No. 2 gear in-position; X2.2= the spindle
No. 3 gear in-position; X2.3= the spindle No. 4 gear in-position.
z Control parameters
State parameter
0 0 1 SPT
SPT =1: The spindle control type: I/O point control.
=0: The spindle control type: frequency conversion or other mode.
The spindle rotation CW/CCW
The spindle stop