Reverse osmosis system
GENO-OSMO RO 125K
Order no. 285 752 940-inter Edited by: phar-mrie G:\BA-752940-INTER_285_RO_125K.DOCX
18
5 | Scope of supply
5.1 Standard
equipment
Stand-alone housing made of opaque PE to accommodate all
aggregates and control elements. Stand-alone housing also serves
as supply tank (only GENO-OSMO RO 125K-TS)
Microprocessor controller with LC display, voltage-free collective
fault signal and voltage-free signal contact (maintenance interval,
various pre-warnings), installed in a stand-alone housing.
Sliding-vane rotary pump made of corrosion-resistant brass with
motor as high-pressure pump to supply the membrane, incl. control
valve for operating pressure and pressure gauge
1)
External pressure booster with pressure switch and
membrane connection vessel for supplying permeate to
downstream consumers
Hydro module for the water supply within the membrane system.
Integrated valves and measuring instruments for easier system
calibration.
Fine filter with integrated pressure reducer preset to 2.5 bar.
Ultra-low pressure reverse osmosis membrane, installed in
pressure pipe made of high-strength PE
Flow sensor to measure the volume of the system flows permeate
and concentrate
Operation manual
1)
Only GENO-OSMO RO 125K-TS
5.2 Optional features
Note:
It is possible to retrofit existing systems with optional
components. Please contact your local Grünbeck representative or
Grünbeck’s headquarters in Hoechstaedt for more information.
Connection block for
GENO-OSMO-RO 125 K
Connection block (installation length 190 mm).
Permeate-resistant incl. two shut-off valves –
suitable for connection set
752 840
Connection set for GENO-OSMO 125K
2 flexible connection hoses DN 15
(L = 600 mm) for feed water and permeate
1 drain hose for concentrate
752 830
Conductivity measurement for
GENO-OSMO RO 125K
As plug-in board to the control electronics.
Display with limit value and delay, incl.
connecting line and conductivity measuring
cell installed in the combi-cap pressure pipe.
752 820
