Instruction manual 1.0.0 rev1 en
GROW
BASE
23
Lights with a 0-10/-10V input can be
connected with a cable that can be
purchased as accessory. Information
regarding the used pins or the RJ45 jack
can be found in the appendix in chapter
9.2.
Advanced setup
Some settings in this section influence the control algorithms of the controller.
These settings are designated to experienced users. If you do not understand a
particular setting, leave it unchanged.
Here only two settings of the section are mentioned. Additional information can be found in
the appendix in chapter 8.
The fan speed of AC fans can’t be decreased without limits. When a certain value is undercut the
fan would not run reliable. How low the fan speed can be reduced, is depending on the particular
AC fan.
To avoid driving the AC fan to low, a value for switch off is defined.
In order to not turn off the corresponding fan, the value for “intake/exhaust MIN/MAX” must
be grater then the corresponding value “AC turnoff”.
Ensure that the fan is still rotating at the set minimum fan speed and the airflow is sufficient for
cooling the motor. This applies for standard duct fans (AC) only.
System setup
In this section, settings such as display contrast and date format can be configured or, for
example, all settings can be reset to the factory settings. In addition, CO
₂
sensors can be
calibrated.
Choose the preferred temperature unit
(°C/°F).
Choose the preferred date format. The
following options are available:
DD:MM:YYYY und YYYY-MM-DD
Intake AC
F
turnoff
m
25A
BC
Exhaust AC
F
turnoff
m
25A
BC
Temperature
F
unit
C
A
C
BC
Date format
F
DD
CMMCYYYY
BC
