Instruction manual 1.0.0 rev1 en
GROW
BASE
25
The “1” on the screen indicates the
number off successfully calibrated
sensors. Please make sure that the
displayed number is matching the number
of actual connected CO
₂
sensors.
The calibration feature is supported by
CO
₂
sensors of the new design:
The sensors with the design shown above
have a configurable filter.
Filter value 1-7:
With a small filter value, the sensor is
reacting quicker to changing conditions
compared to a high value. The noise also
increases with a small filter value.
Filter value 0:
With this filter value the filter is
automatically adjusted to the prevailing
conditions. This setting usually is the best
choice.
In order to send the previously set filter
value to the CO
₂
sensors, choose “OK” and
confirm the action by pressing the button.
After a successful transfer of the filter
value, a message similar to the “Apply
calibration”.
In order to restore all factory settings,
choose “OK” and confirm by pressing the
rotary switch.
Please note that this action also resets the
functions of the power sockets on the
controller. We recommend to remove all
devices that are connected to the power
sockets prior the reset.
Functions associated with the individual
power sockets on the controller with
factory default:
Multi Out 1: Intake AC
Multi Out 2: Exhaust AC
Multi Out 3: Humidifier
Multi Out 4: Lights
Multi Out 5: Lights
This screen shows the currently installed
firmware version.
This function is intended to be used for
updating the firmware. To update the
firmware, the rotary switch has to be
pressed while the controller is starting. A
detailed description for the firmware
update can be found in chapter “firmware
update”.
Filter CO2
F
sensor
C 0
BC
Apply filter
F
CO2
BC
Restore fact.
F
settings
BC
Firmware info
C i
5045.0.00.04
BC
Restart
F
device
BC
