29
W450769A 01/14
4.
Perform Piston Calibration. Press the
Yes
or
No
button.
a. Press
No
to enter the known piston diameter. Press
Yes
to go to the screen to calibrate
cylinder diameter.
b. Press
Yes
to calibrate the load. Enter the load in tenths, including the load, hook ball,
and load handling slings. Press the
Exit
button to save the weight and go the next part
of the routine.
5.
Next the system will prompt for the load to be raised. Slowly raise the load clear of the ground
and steady it. When you are ready to proceed with the calibration of the load, press
Yes
.
6.
The system will then prompt for the measured load radius measurement. Carefully measure
from the center of the load to the centerline of rotation of the crane and enter the dimension in
feet and tenths.
7.
Press the
Exit
button to enter the corrected radius and prompt for the load to be put down.
Ensure the load is completely on the ground and the hook back and load handling equipment is
not hanging. When this is accomplished, press
Yes
.
8.
You will be prompted to again pick up the load.
9.
Press
Yes
to calculate the piston diameter and revert back to the main menu
06 Pressure
. This
pressure routine is complete.
TEST
SET
TEST
SET
TEST
SET
TEST
SET
