26
W450769A 01/14
Menu 04 – Angle Sensor
This menu is used to enter the zero point and span for the angle sensor.
1. Press the
Menu Up
or
Menu Down
buttons until
“04 Angle Sensor”
appears in the information
window at the right.
2. Press the
04 Angle Sensor
button to enter the routine.
3. With the boom in a horizontal position, press the
Zero Angle? = XXX
button.
4. Press the
Span Angle? X.X
button.
5. Raise the boom until the inclinometer reads 60° or slightly higher. Enter the value for the angle
from the inclinometer.
6. Use the
B
and
C
buttons adjacent to the numerical values at the bottom of the window to scroll
left or right and highlight each number.
7. Use the
A
button to enter the number. When complete, the menu will automatically change to
the previous menu.
8. To exit the routine without changes, press the
Exit
button.
NOTE: Enter measurements in degrees and tenths (xx.xx). If necessary, convert recorded
measurements before starting.
9. When you have finished, press
Exit
button to return to the main menu.
TEST
SET
TEST
SET
A
B
C
D
