CIP1300 – Use and Maintenance Manual
27
Chapter
11
ORDINARY MAINTENANCE
CAUTION
:
Danger of injury
To carry out the operations described above it is obligatory to
wear protective gloves, glasses or a protective visor, and safety
shoes.
CAUTION:
Excess oil must be removed to avoid it leaking out and polluting
the ground.
CAUTION:
Before any maintenance or adjustment operation, switch off the
engine and remove the key from the control panel.
11.7 Maintenance of the spark ignition engine
N.B. : Consult the engine use and maintenance handbook provided at the time of
delivery.
11.8 Checking and replacing the hydraulic oil
The hydraulic oil tank is provided with a
visual oil level indicator
(A).
Check the level periodically, and, when
necessary, top up with “
Roloil LI 46
”. The
oil must be replaced every 800 hours of
operation or every 18 months..
To replace it proceed as follows:
−
unscrew the plug of the tank
(T)
−
unscrew the bottom drainage plug, taking
care to collect the oil with a receptacle
−
put back the drainage plug
−
put oil into the tank until it reaches the
level shown on the indicator
−
close the tank by screwing in the top
plug.
11.9 Replacing the hydraulic oil filter
The hydraulic oil filter must be replaced after
the first 100 hours of work and then every
300 hours.
Unscrew and replace the cartridge.
Bring the oil level in the tank back up,
checking on the visual indicator.
The MAX pressure of the system must not
exceed 170 Bar. The MAX pressure
regulation is done in the factory and must in
no case be tampered with.
A
T