GRAPHTEC CELITE-50, Руководство пользователя

Страница: 100 / 128

5-22
Chapter 5 Detailed Settings
Setting the Media Width Detection
This device uses the width detection sensor to detect the leading edge/ width/ position of the media.
Depending on the type of media (especially with high transparency), the media cannot be set correctly because
of the detection error for the leading edge/ width/ position of the media.
In such a case, use a carrier sheet or disable media width detection according to the following procedures.
Remove the media before setting the media width detection. It cannot be set correctly when media is loaded.
1.
From the "MENU" screen, select "MEDIA
1/3" and proceed to the "MEDIA 3/3"
screen.
2.
Select "ON" or "OFF" for "WIDTH
DETECTION".
When "ON" is
selected
When "OFF" is
selected
3.
Depending on the setting, the display on the "LOAD MEDIA"
screen on the "HOME" screen will change.
When set to "ON", select the shape of the media.
When set to "OFF", select the size of the media.
The media size is treated as "A3" if "A4/A3/B4/8"/11"" is
selected.
The media size is treated as "A2" if "A3+/A2/B3/12"/15"" is
selected.
The media size is treated as "20"" if "B2/17"/20"" is selected.
CAUTION
When setting it to "OFF", do not cut the data exceeding the set
media size. The device cuts the outside of the media, so that the
cutter pen and the cutting mat may be damaged.
<Note>
This setting can also be specified on the "LOAD MEDIA" screen.
1.
Touch the "LOAD MEDIA" on the "HOME" screen.
2.
Touch the " (Page)" to display the "WIDTH DETECTION"
screen.