Graco Reactor 2 E-30, Запасные части

Страница: 55 / 98

Repair
Replace Fluid Inlet Sensor
Note
For Elite models only.
1. Perform Shutdown, page 43 .
2. Perform Pressure Relief Procedure, page 42 .
3. Disconnect inlet sensor cable from the fluid inlet
assembly. Inspect cable for damage and replace
if necessary. See Electrical Schematics, page 89 .
Figure 9 Fluid Inlet Sensor
4. To replace sensor cable:
a. Open wire bundle and remove sensor cable.
b. Cut any wire ties and disconnect from MCM.
See Electrical Schematics, page 89 .
NOTICE
To prevent damage to cable, route and secure
cable in wire bundle with wire ties.
5. Replace sensor (602).
Replace Pressure Transducers
1. Perform Shutdown, page 43 .
2. Perform Pressure Relief Procedure, page 42 .
3. Disconnect transducer cables (405) from #6 and
#7 connectors on the MCM.
4. Remove wire ties constraining transducer cable
and remove cable from cabinet.
5. Install o-ring (416) on new transducer (405).
6. Install transducer in manifold. Mark end of cable
with tape (red=transducer A, blue=transducer B).
7. Route new cable into cabinet and thread into
bundle as before. Attach cable ties to bundle
as before.
8. Connect A side pressure transducer cable
to MCM port #6. Connect B side pressure
transducer cable to MCM port #7.
405
416
405
401
333024A 55