![background image](http://html1.mh-extra.com/html/graco/efr/efr_instructions-parts-list-manual_2251283013.webp)
Installation
3A6165J
13
NOTE:
Inside the junction box, power wires are
pre-installed to terminals 2T1 and 4T2 on the disconnect
block. Refer to F
. 7 for the terminal locations.
3. Insert the power cord through the cord grip (strain
relief) 3/4-14 NPT male, cable range 0.35-0.63 in.
(8.9-16 mm), and into the junction box.
4. Attach the ground wire to the ground terminal inside
the junction box as shown in F
5. Refer to F
. 7 and connect the wires from the
power cord into terminals 1L1 and 2L2.
NOTE:
For 480V systems, a step-down transformer is
factory-installed between the power disconnect switch
and the electric driver. See
on page
65.
NOTE:
Do not attach the ground wire to the grounding
lug locknut on the outside of the electric driver. See
on page 12.
6. Place the power wires into the open area on either
side of the power disconnect switch (C) as space
permits.
7. Reinstall the junction box cover (BA) and disconnect
switch (C) using the four screws removed in step 2.
8. Tighten the cord grip to securely hold the power
cord in the junction box.
F
IG
. 7: Terminal Connections
F
IG
. 8: Connect Power
WLE
/
/
/
7
7
7
WLD
BA
C
WLD
Cord Grip
NOTICE
Make sure all wires are routed correctly before instal
-
lation. If wires get pinched when the screws are tight
-
ened, damage will occur.
F
IG
. 9: Tighten Cord Grip
WLD