Goldacres Super Cruiser G8, Руководство оператора, Страница: 9 / 210

Chapter 2 - Safety - 5 G8 Super Cruiser Operator’s Manual MY19 - REV 0
CAUTION: Always refer to the chemical
manufacturers label for guidelines on the appropriate
PPE to use with the chemical/s you are using.
Goldacres also suggests that you read and understand
the following Australian standards:
• Australian Standard for Chemical
protective clothing AS3765.
• Australian Standard for Respiratory
protection devices AS1715.
Poisons Information Centres - Call 131 126 (AU)
Cuts, Stabs & Punctures
When Servicing machine, be mindful of sharp edges
on parts such as trimmed cable ties, hose clamps, cut
reinforced hose and the edges of plates and brackets
as they could cause cut, stab or puncture injuries.
Crush Hazard
Never attempt to maintain axles, wheels or
components within the vicinity of the wheels with the
engine running.
Pinch Hazard
When operating moving components such as the
boom, access ladder, bonnet or other components,
keep fingers and hands away from potential pinch
points.
Burn Hazard
• Avoid contact around the entire exhaust system of
the sprayer when at operating temperature
• Avoid contact around the hydraulic tank and all
hydraulic lines when at operating temperature
Entanglement Hazard
Rotating drives can cause serious injury or even death
when entanglement occurs. Keep hands, feet, hair and
clothing away from all moving parts to prevent injury.
Never operate this machine with covers, shrouds, or
guards removed.
Stored Energy Hazard
Even when the machine is not running, energy can be
stored in components such as hydraulic accumulators,
air tanks, tyres, A/C hoses, springs and boom cables.
Hydraulically supported components such as the
boom center are also a source of stored energy.
Before working on the machine, ensure that these
parts are relieved of their energy in a safe manner.
Overhead Hazard
BOOM LIFT OR TILT AND RADIO ANTENNA
COULD STRIKE POWER LINES. Keep clear of
overhead obstructions – especially power lines as
contact can be fatal.
Do NOT walk on machine platform when near
power lines.
Airborne Particles
• Always stand well clear of equipment during
operation.
• Any spray drift is dangerous and may be hazardous
to humans and other animals.
• When heating and welding components, ensure
that all paint and other such materials are removed.
Often hazardous airborne particles and fumes are
generated from welding and heating.
Fluids Under Pressure
Fluids escaping from high pressure lines can cause
serious injury to skin. Hydraulic oil can easily penetrate
human skin. This hazard can be avoided by relieving
the pressure in the system.
Do not disconnect any hoses, nozzles or filters
while equipment is operating. Disconnecting these
components while under pressure may result in
uncontrolled fluid discharge which may be hazardous.
Be mindful of the location of pressurised lines in the
vicinity of the work area when using equipment such
as grinders, oxy torches and welders. The two main
risks are that this equipment may easily cut through
the lines or the local heat generated near the lines
may cause them to rupture.
Ensure that all fittings and lines are fully/tightly secured
before re-pressurizing after repairs.
Boom Height Control System
If boom height control system is fitted, keep clear of
the boom as it could potentially move without notice.
Cooling System
• At operating temperature the fluids in the cooling
system are under pressure. Only remove the
radiator cap when the engine is turned off and has
cooled down.
• Loosen the radiator cap slowly to relieve the
pressure before removing the cap completely.
• Coolant can be added when the engine is cool and
turned off.
Batteries
The machine is supplied with sealed, non-serviceable
batteries. The battery electrolyte contains sulfuric acid;
this is a highly dangerous liquid and should be handled
with the greatest degree of care.
Safety Information
Continued over page