GLP Fusion Par FP7, Руководство пользователя

Страница: 20 / 40

www.glp.de
20 Fusion Par FP7 User Manual Rev. A
No DMX
You can set the fixture to react in three different ways if no DMX signal is present (if the
fixture is being controlled by DMX but the DMX signal stops, or if you apply power to
the fixture when no DMX signal is present):
●
Shut off sets the fixture to black out. This is the default setting.
●
Hold sets the fixture to continue obeying the last DMX values it received.
If no DMX signal was being received, the fixture will black out.
●
Play P1 / P2 / P3 sets the fixture to show the program that has been stored in the
St Alone

P Edit menu (see ‘P Edit’ on page 23).
To avoid any possibility of unexpected behavior from a powerful strobe light if the DMX
signal fails, we recommend that you set the fixture to Shut off when you are not running
a stand-alone program.
DMX Live
DMX Live lets you view the current refresh rate of the DMX signal that the fixture is
receiving.
It also lets you see the DMX values that the fixture is receiving for each individual
effect.
Personal
D Curve
See Figure 7. You can select from four dimming curves using the control panel or the
Control / Settings DMX channel:
●
Linear sets dimming so that it appears to increase and decrease evenly throughout
the dimming range.
●
Theatrical (Theat) is an S-shaped curve that gives finer control at low and at high
light levels.
●
Square Law (Square) gives finer control at low light levels and coarser control at high
light levels.
Figure 7. Dimming curves