GLP Fusion Par FP7, Руководство пользователя

Страница: 16 / 40

www.glp.de
16 Fusion Par FP7 User Manual Rev. A
Fasten the rigging clamp around a truss chord to mount the fixture on the rigging
truss.
Secure the fixture with a safety cable as directed on page 15.
Fastening to a surface
You can use the Floorstand / Mounting bracket to fasten the FP7 to a suitable secure
surface at any angle.
To mount the FP7 on a surface:
Prepare a suitable hole in the mounting surface, adding a means of anchoring the
fastener such as a screwplug if necessary.
Pass a high-strength M10 bolt or screwbolt through the hole in the center of the
mounting bracket yoke (see D in ‘FP7 overview’ on page 11) and fasten it into the
surface.
Secure the fixture with a safety cable as directed on page 15.
Connecting to power
Warning!
Read ‘Safety’ starting on page 4 for important safety information
that you must understand before you connect the fixture to power.
The AC mains power supply must include a connection to ground / protective earth. It
must be protected against ground / earth leakage and overload. The autosensing
power supply accepts AC power at 100-240 V, 50/60 Hz. Do not connect the fixture to
power at any other voltage or to an external dimmer.
The Fusion FP7 does not have a power ON/OFF switch. Power is applied to the fixture as
soon as the power cord / power cable that is connected to the fixture becomes live.
The FP7 has a 3-conductor IP65-rated Neutrik powerCON socket that accepts AC
power from a Neutrik powerCON TRUE1 IP65-rated female cable connector.
To connect the fixture to power:
Check that power to the power input cable is shut down.
See Figure 2 on page 11. Connect the power input cable to the MAINS IN socket
by lining up the key (tab) on the cable connector carefully with the keyway (slot) in
the MAINS IN connector, then inserting and twisting the cable connector clockwise
to lock. You should hear a ‘click’ when the connector is locked. Do not force the
cable connector – if it feels excessively stiff, remove it and check that the key and
keyway are correctly lined up.
Do not expose the cable connector to bending forces by letting cable hang from
the connector, for example, as this may affect its ingress protection and allow
water to enter the connection.
To remove the power input connector, pull the locking latch towards you to release it,
then twist the connector counterclockwise and remove it from the socket.
Install the rubber connector seals on any unused connectors.