Model C53 Conductivity Analyzer (universal-mount 1/2 DIN)
Rev. 5-1000
10
T A B L E O F C O N T E N T S ( c o n t i n u e d )
SECTION 3
DISPLAY CONTRAST VISIBILITY
............................................................... 37
SECTION 4
ANALYZER CONFIGURATION
4.1 Selecting LANGUAGE to Operate Analyzer.......................................... 37
4.2 Configuring Sensor (A and B) Characteristics:
SELECT MEASURE (conductivity, resistivity or TDS) ................38-39
Select DISPLAY FORMAT ..........................................................39-40
Select Temperature COMPENSATION............................................ 40
CONFIG TDS Measurement
(not needed for other measurements) ........................................ 41
CONFIG LINEAR Temperature Compensation
(not needed for other compensation methods)......................42-43
SELECT CELL K (sensor’s GLI-certified “K” value) ......................... 43
SET FILTER Time............................................................................ 44
Select PULSE SUPPRESS (on/off).................................................. 44
ENTER NOTE (top line of MEASURE screen) .................................. 45
Select TEMP ELEMENT Type ....................................................45-46
SET T FACTOR (sensor’s GLI-certified “T” factor) .....................47-48
4.3 Configuring Calculated Sensor A and B Measurement:
SELECT MEASURE (none, % rejection, % passage,
ratio A/B, ratio B/A, difference A-B or difference B-A) ................ 48
Select DISPLAY FORMAT (only for ratio A/B or ratio B/A;
not needed for other calculated measurements) ........................ 49
4.4 SET
°
C OR
°
F (temperature display format) ......................................... 49
4.5 Configuring Analog Outputs (1 and 2):
SET PARAMETER (representation) ...........................................50-51
SET 0/4 mA and 20 mA VALUES (range expand) ........................... 51
SET TRANSFER Value (mA) ........................................................... 52
SET FILTER Time............................................................................ 52
Select SCALE 0 mA/4 mA (low endpoint) ........................................ 53
4.6 Configuring Relays (A, B, C, and D):
SET PARAMETER (representation) ...........................................53-54
SET FUNCTION Mode (alarm, control or status)........................54-55
SET TRANSFER Mode (relay on or off) .......................................... 55
ACTIVATION (configuration values) ...........................................56-57
4.7 SET PASSCODE (feature enabling or disabled)................................... 58
4.8 Configuration Setting Summary (ranges/choices and defaults) .......59-61
SECTION 5
ANALYZER CALIBRATION
5.1 Things to Know About Calibration ....................................................62-63
5.2 Zero Procedure (first-time sensor calibration only) ..........................63-64
5.3 DRY-CAL Method (highly recommended):
SELECT CELL K (sensor’s GLI-certified “K” value) ....................64-65
SET T FACTOR (sensor’s GLI-certified “T” factor) .....................65-67
