GILES GGF Series, Руководство по эксплуатации и обслуживанию

Страница: 57 / 96

49
Model: GGF-400, GGF-720
Fryer Operation
5.1.10 Controller Errors & Alarms
Continued on Next Page
ERROR CODE DESCRIPTION (Upper Display) PROBLEM
OPEN DRAIN IS OPEN
Drain valve is open, or not completely closed. Basket will be
raised, if down. Close drain to clear error.
----
CHECK OIL LEVEL, ENSURE VAT IS
FULL, IF FULL THEN PRESS
[START]
This is a secondary error displayed after closing drain clears the
OPEN error; confirmation of oil level.
ER03
LOW OIL LEVEL – ENSURE VAT IS
FULL (Element/Add Level
Differential Warning)
The oil level is below the [ADD] line in the vat. Add oil to the
[FULL] level mark & stir. Error will remain in effect until probe
temp differential is resolved.
ER06
LOW OIL LEVEL – ENSURE VAT IS
FULL – PRESS [START]
(Post ER03 Warning)
After an ER03 is cleared, this is displayed until user presses
[START] to confirm oil level.
ER07
MAX ELEMENT TEMP – PRESS
[START] (Post Warning)
Error is displayed after MAX element temperature (ER19) has
occurred and element has cooled below MAX temperature, .
ER13 OIL PROBE Error
Problem with the variable oil temp probe . Service technician
generally required.
ER15 ELEMENT PROBE Error
Problem with element temp probe , attached directly to heating
element. Service technician generally required.
ER17 ADD LEVEL PROBE Error
Problem with add level probe at vat [ADD] mark. Fryer without
this probe should have ELMT-ADD DIFF ENABL E setting [OFF] in
Factory Settings . Probe cannot be bypassed . Service technician
generally required.
ER19 MAX ELEMENT TEMP Error
The maximum heating element temperature has been exceeded.
This is a safety device; NEVER bypass this Probe .
ER25 GUARD BAND EXCEEDED
Actual oil temperature deviates from setpoint by the Guard Band
amount. Allow oil to cool, or heat, to within range. Factory
ER37 EEPROM Error
An error occurred while saving settings to the EEPROM. Contact
Giles Tech Service (800.554.4537).
ER38 Internal ADC Error
The ADC (Analog-to-Digital Converter) chip has stopped working.
MCB1 board must be replaced. Contact Giles Tech Service
(800.554.4537).
Conditions which can cause unsafe operation or damage to the unit (open valves,
low oil level, high temp, hood problems, etc.) will halt operation, activate an alarm
tone and display error codes/messages. Error Codes are
shown on the Lower 7-Segment Display ; error messages and
prompts are shown on the Upper OLED Display . Generally,
heating elements are disabled until error condition has been
corrected. Pressing the [ALARM] key silences the alarm tone,
but does not clear error. Error Codes are shown in the Table
below and further details are discussed in the following section.
OLED
7-Segment
ALARM