26
Positioning toothed-belt lock
1. Close the door leaves.
2. Loosen the screws (1) and (2) on the locking device.
3. Align the locking device to the toothed belt.
After installation the locking pin must be positioned above the hole in the hood so
that it can be locked and unlocked.
Enlarge hole if necessary.
4. Tighten bolts (1).
5. Set the locking device guide (3) so that the toothed belt neither contacts nor has
too much air. To this purpose loosen 2x Inbus-Ripp screws (2), move the locking
device guide (3) and tighten the screws (2) again.
6. Lightly lubricate sliding surfaces.
Positioning bolt lock
See installation instructions Id. No. 106944.
Installing safety equipment
➮
Install motion detector.
For electrical installation, see terminal connection diagram.
Installing switches/buttons
For electrical installation, see terminal connection diagram.
1
3
2
The driver may not contact the lock during operation!
