11
5. Push sliding block (3) toward motor (arrow). When doing so, leave a gap of
approx. 2 mm between sliding block and motor.
6. Tighten bolt (4).
7. Insert a large flat-head screwdriver into the gap between the sliding block and
motor and loosen bolts (2).
8. Press motor to the right with the screwdriver to tension the toothed belt (5)
(displacement force F at motor is approx. 300 N).
9. Tighten bolts (2) again.
3.8
Installing controller
1. Install both tensioning plates (1) to the flat sliding blocks (2) in the runner with
M6 x 8 Inbus-Ripp locking bolts.
2. Place controller (3) on the runner and push tensioning plates (1) into controller (3).
See block diagram for controller position.
– Slimdrive SL:
DCU1 controller
– Slimdrive SL-FR 2M:DCU1-2M controller
3. Tighten bolts.
3.9
Installing battery
➮
Position battery (1) (see block diagram) and install with M6 x 8 Inbus-Ripp locking
bolts.
1
2
3
1
Do not yet tighten the screws of the tensioning plates (1); it must be possible to move
the tensioning plates.
1
