getemed VitaGuard VG310, Руководство по эксплуатации, Страница: 44 / 118

44 Steps before and after monitoring
for this time and the remaining time is shown next to it. Text mes-
sages, on the other hand, are shown from the beginning.
When no patient cable is connected, an acoustic reminder signal is
emitted as a short tone
every twenty seconds after the monitor is
switched on. The technical alarm for cable monitoring is not activated
until the patient cable is connected and the first plausible data have
been calculated. A text message in the status line reports from the
beginning that the cables are being checked.
After the device has been switched on, the following displays and
signals show you that the monitoring system is fully operable.
All indicator LEDs light up briefly. During this time the alarm LED
first lights up red and then yellow.
A brief tone is emitted to indicate that the acoustic alarm buzzer
is fully operable.
If the alarm buzzer does not emit the acoustic signal after the device
has been switched on, you must immediately send VitaGuard® to
getemed AG or your authorized dealer for inspection. Please consult
your authorized dealer for a replacement device.
Observe the patient carefully until the replacement device arrives.
Bear in mind that the patient is not being monitored at this time
and that no alarm will be reported in an emergency.
5.3 Switching off
Always switch off VitaGuard® in the manner described here.
1 Press the <Enter> key and keep this pressed: the message
Press
Esc key
appears.
2 Briefly press the <Esc> key, still keeping the <Enter> key pressed,
and then release both keys.
The switch off command is acknowledged by two short beeps.