Gestetner B147, Руководство по обслуживанию

Страница: 444 / 1081

FIRMWARE UPDATE
B147/B149/B190 5-156 SM
5.6.9 HANDLING FIRMWARE UPDATE ERRORS
If an error occurs during a download, an error message will be displayed in the first
line. The error code consists of the letter “E” and a number (“E20”, for example).
Error Message Table
Code Meaning Solution
20
Cannot map logical address Make sure SD card inserted correctly, or use
another SD card.
21 Cannot access memory HDD connection incorrect or replace hard disks.
22
Cannot decompress
compressed data Incorrect ROM data on the SD card, or data is
corrupted.
23
Error occurred when ROM
update program started Controller program abnormal. If the second attempt
fails, replace controller board.
24
SD card access error Make sure SD card inserted correctly, or use
another SD card.
30
No HDD available for stamp
data download HDD connection incorrect or replace hard disks.
31
Data incorrect for continuous
download Insert the SD card with the remaining data required
for the download, the re-start the procedure.
32
Data incorrect after download
interrupted Execute the recovery procedure for the intended
module download, then repeat the installation
procedure.
33
Incorrect SD card version Incorrect ROM data on the SD card, or data is
corrupted.
34
Module mismatch - Correct
module is not on the SD card) SD update data is incorrect. Acquire the correct
data (Japan, Overseas, OEM, etc.) then install
again.
35
Module mismatch – Module on
SD card is not for this machine SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct update
data then install again.
36
Cannot write module – Cause
other than E34, E35 SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct update
data then install again.
40
Engine module download
failed Replace the update data for the module on the SD
card and try again, or replace the BCU board.
42
Operation panel module
download failed Replace the update data for the module on the SD
card and try again, or replace the LCDC.
43
Stamp data module download
failed Replace the update data for the module on the SD
card and try again, or replace the hard disks.
44
Controller module download
failed Replace the update data for the module on the SD
card and tray again, or replace controller board.
50
Electronic confirmation check
failed SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct update
data then install again.