Gentex HGU-84/P, Инструкция по эксплуатации и обслуживанию

Страница: 20 / 62

2-6. ANVIS MOUNT MOD I FI CA TION (DUAL VI SOR AS SEM BLY)
Be fore the ANVIS NVG can be in stalled, the ANVIS mount must be mod i fied and a
ca ble clip at tached. The ANVIS mod i fi ca tion kit con tains four screws for the rear of the
mount, a ca ble clip and at tach ing screw, and pile fas tener for ANVIS bat tery pack at -
tach ment to the hel met. Re ferring to Fig ure 2-14, per form the mod i fi ca tion as fol lows :
1. Re move the nut from the right side (as worn) of the ANVIS mount, and place the
strain re lief clamp over the end of the screw threads.
2. Place the wires un der the clamp arm, and re place the nut over the clamp and screw
threads. Tighten the nut un til se cure.
3. Po si tion the back ing plate on the rear of the mount so that the screw holes are
aligned and the plate is flush with the top and bot tom of the rear of the mount.
En sure that the wires ex tend ing from the rear of the mount are aligned in the slots in
the mount to pre vent crush ing of the wires.
4. Ap plying a small amount of thread lock ing ad he sive to the threads of each lo cat ing
pin, se cure the back ing plate to the mount with the pins. En sure that the two pins
with the lon ger ta pered heads are in stalled in the two top holes. Tighten the pins
un til se cure, but do not over-tighten them.
5. Re move the back ing from the hook fas tener. Wrap the hook fas tener around the
ca ble con nec tor un til the ends meet as shown in Fig ure 2-14.
2-13
Fig ure 2-14. ANVIS Mod i fi ca tion Kit (*P/N 90A7946-6)
* TOP LO CATING PINS
(LONG TAPERED HEADS)
* BOT TOM LO CATING PINS
(SHORT TAPERED HEADS)
* BACKING PLATE
* CA BLE STRAIN RE LIEF
CLAMP (SHOWN IN STALLED)
* HOOK FAS TENER
(SHOWN IN STALLED)
ANVIS MOUNT, CFE
(CUS TOMER
FUR NISHED
EQUIP MENT)