Genie Z-80/60, Руководство оператора

Страница: 38 / 65

Operator's Manual Sixth Edition • Sixth Printing
Inspections
36 Z-80/60 Part No. 226482
Test the Steering
(models with 2 wheel steer)
53 Press down the foot switch.
54 Press the thumb rocker switch on top of the
drive control handle in the direction indicated
by the blue triangle on the control panel OR
slowly move the control handle in the direction
indicated by the blue triangle.
Result: The steer wheels should turn in the
direction that the blue triangles point on the
drive chassis.
55 Press the thumb rocker switch in the direction
indicated by the yellow triangle on the control
panel OR slowly move the control handle in
the direction indicated by the yellow triangle.
Result: The steer wheels should turn in the
direction that the yellow triangles point on the
drive chassis.
Test Drive and Braking
56 Press down the foot switch.
57 Slowly move the drive control handle in the
direction indicated by the blue arrow on the
control panel until the machine begins to move,
then return the handle to the center position.
Result: The machine should move in the
direction that the blue arrow points on the drive
chassis, then come to an abrupt stop.
58 Slowly move the control handle in the direction
indicated by the yellow arrow on the control
panel until the machine begins to move, then
return the handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
drive chassis, then come to an abrupt stop.
Note: The brakes must be able to hold the
machine on any slope it is able to climb.
Test the Oscillating Axle (if equipped)
59 Start the engine from the platform controls.
60 Drive the right square-end tire up onto a 15 cm
block or curb.
Result: The three remaining tires should stay
in firm contact with the ground.
61 Drive the left square-end tire up onto a 15 cm
block or curb.
Result: The three remaining tires should stay
in firm contact with the ground.
62 Drive both square-end tires up onto a 15 cm
block or curb.
Result: The circle-end tires should stay in firm
contact with the ground.