Genie Z-80/60, Руководство оператора

Страница: 35 / 65

Sixth Edition • Sixth Printing Operator's Manual
Inspections
Part No. 226482 Z-80/60 33
Test the Operating Envelope
15 Press the LCD screen
control buttons shown until
PRI BOOM ANGLE TO
GRAVITY is displayed.
16 Raise the primary boom and observe the LCD
screen.
Result: The primary boom should raise and the
LCD screen should display the primary boom
angle in degrees from 35 to 65. The primary
boom should stop when the screen reads
65 degrees.
17 Lower the primary boom.
18 Simultaneously press the 2
LCD screen control buttons
shown to activate status
mode.
19 Press the LCD screen
control buttons shown until
SEC BOOM ANGLE is
displayed.
20 Press and hold the secondary boom up/extend
button.
Result: The secondary boom should raise and
the LCD screen should display:
=0
>0
>35
=65
The secondary boom should raise and then
extend. The secondary boom should not
extend until it is fully raised.
21 Press and hold the secondary boom
down/retract button.
Result: The secondary boom should fully
retract and then lower. The secondary boom
should not lower unless it is fully retracted.
At the Platform Controls
Test Emergency Stop
22 Turn the key switch to platform control.
23 Push in the platform red Emergency Stop
button to the off position.
Result: The engine should shut off and no
functions should operate.
24 Pull out the red Emergency Stop button and
restart the engine.
Test the Hydraulic Return Filter
25 Press the engine idle speed select button or
move the switch until the indicator light next to
the high idle (rabbit symbol) is on.
26 Locate and check the hydraulic filter condition
indicator.
Result: The filter should be operating with the
plunger or the needle in the green area.
27 Press the engine idle speed select button or
move the switch until the indicator light next to
the foot switch activated high idle (rabbit and
foot switch symbol) is on.
Test the Horn
28 Press the horn button.
Result: The horn should sound.