16
WI850A GEM-P800 Installation Instructions
7HOHSKRQH 1XPEHU 3URJUDPPLQJ
[30]Subscriber ID Number
For 4/2 format enter a 4 digit number. If 3/1
format is required, enter a 3 digit number,
then press the
key to blank the last
digit.
[31]Telephone Number 1
Program the phone number to be dialed for
Telephone Number 1. Program the number
directly, just as it is entered on a TouchTone
phone. A fixed Dial Tone Detection (E) is
included prior to the
Dialing Prefix (Block
Number 44)
. Programming an E is not re-
quired for
Telco 1, Telco 2 and Telco 3. If
dial tone detection is not desired select
No
Dial Tone Detection in Communicator Fea-
tures [46-1].s Use the
key to blank out
remaining digits in the phone number.
[32]Receiver Format
Select the receiver format to be used to
report for Telephone Number 1: Program a
0 to disable reporting to Telco 1.
[0] Disabled
[4] Universal High Speed
[1] Ademco Slow
[5] Reserved
[2] Radionics Slow
[6] Point ID
[3] Silent Knight Fast
[7] Pager
[33]Receiver Options
(1) 2300 Hz HS/Kissoff - Select 2300 Hz
Handshake and Kissoff.
(2) Sumcheck - Only used for the following
Receiver Formats: Ademco Slow, Radion-
ics Fast, Silent Knight Fast and Universal
High Speed. This is a sophisticated data
format used to enhance the speed and
check the accuracy of the received trans-
mission. This format should be used when-
ever the central station has this capability.
Instead of sending a second round to verify
correct data, the panel sends a Sumcheck
digit after sending the Subscriber ID and
Alarm Code.(3) Single Digit - 3/1 Format.
3-digit Subscriber ID number and a 1-digit
Alarm Code will be transmitted.
(4) No Handshake - (All receiver formats
except Pager Format)
If programmed no Handshake/Kissoff is re-
quired by the panel.
[34]Zone Report, Telco 1
Select zone(s) required to send an alarm
report to Telephone Number 1.
[35]Zone Restore Report, Telco 1
Select zone(s) required to send a restore
report to Telephone Number 1. The zones
will send a restore after Bell time-out, un-
less programmed as silent zones.
[36]System Reporting, Telco 1
(1) Keypad Fire - Program to activate a
Keypad Fire report (
).
(2) AUX/AMBUSH - Program to activate an
AUX or AMBUSH report (
).
(3) Panic - Program to activate a Panic
report (
).
(4) Test Timer - Program to activate a Test
Timer report.
[37]System Reporting, Telco 1
(1) AC Fail Report - Program to activate an
AC Fail report (15 minute fixed report delay).
(2) Low Battery Report - Program to acti-
vate a Low Battery report.
(3) *Trouble Report - Program to activate a
Trouble report.
(4) Fire Report - Program to activate a Fire
report.
*Includes Bell Cut, Fire Trouble, Receiver
Fail-to-Respond, Receiver Tamper, Receiver
JAM, Wireless Smoke Low Battery, Wireless
Smoke Supervisory Fail. Point ID format will
report trouble(s) by device and ID number.
[38]System Restore Report, Telco 1
(1) AC Restore - Program to activate an AC
Restore report.
Wi850a
page 16
Tuesday, September 16, 1997 08:01
