GE T1000, Техническое руководство

Страница: 204 / 302

GE Reason Switches Chapter 7
– Configuration
204 REASON SWITCHES-TM-EN-3
treated as configured at the Action Parameters. Possible
configuration are as follows:
 DMAC : indicates type of destination MAC address.
Possible values are Any, which means all MAC addresses
types, Unicast, Multicast and Broadcast MAC addresses;

SMAC : indicates OUI value of source MAC address to be
applied as filter. Possible values are Any, which means all
MAC addresses, and Specific MAC address. If specific is
selected, the OUI field of the MAC address will be used as
a parameter. Allowed values are hexadecimal values, and
each byte should be sep
arated by a “ - “ signal;

Tag : indicates if frame to be applied in this QCE would be
tagged or untagged. Possible values are Any, which
means no filter based on VLAN identifier number, Tagged
and Untagged values;
 VID : indicates VLAN identifier to be used as a filter, if Any
of Tagged was selected as options at the Tag field.
Possible values are Any, which means all VLAN identifier
numbers, Specific and Range. If specific is selected, the
Value field must be filled with VID number desired, and
allowed values are the VLAN range values (from 1 to
4,095). If range is selected, the From and To fields must be
filled with VID range numbers desired, and allowed values
are the VLAN range values (from 1 to 4,095);

PCP : indicates PCP values to be applied as filter at the key
parameters. Allowed values are the PCP range values,
from 0 to 7;
 DEI : indicates DEI value to be applied as filter at the key
parameters. Allowed values are the DEI range values, 0 or
1;

Frame Type : indicates frame type to be used as filter at
the key parameters. Allowed values are Any, EtherType,
LLC, SNAP, IPv4 and IPv6. Possible configuration is as
follows:

Any: indicates that all incoming frames will be
used at this QCE;

EtherType : indicates which ethertype will be
allowed in this QCE. When selected, the
Ethertype Parameters will be displayed. Possible
configuration is as follows:
o
Ethertype : indicates which filter should be
applied based on the ethertype field on the
frame. Possible configuration is as follows:
o
Any: indicates that all incoming frames will
be used at this QCE;