GE 60000 Series, Руководство по установке и запуску

Страница: 21 / 120

21
Compare this illustration with your generator to familiarize yourself with the location of these connections.
System Connectors
A ‑ Fuse Block — Used to connect utility 240 VAC from
fuse block in ATS to the control board. Connect only
one wire per terminal.
B ‑ Two‑Pin Terminal Block — Used to connect start
signal wires to the control board. Connect only one
wire per terminal. Torque connector plug screws to 7
in-lb (7.9 Newton meter).
• For power output connection, use 300 volt, 167 °F-194 °F (75
°C-90 °C) wire. See chart on right for proper wire size.
• For Utility Circuit connection use #14 AWG minimum 300
volt, 167 °F-194 °F (75 °C-90 °C) wire.
• For transfer switch communication use #18 AWG twisted
pair conductors, no greater than 200 ft (60 m) in length,
300 volt, 167 °F-194 °F (75 °C-90 °C) wire.
GND
UTILITY A UTILITY B
317371
315047
REMOTE
START
CONTACT
80005289
D
A
B
D ‑ Power Connection (Line 1, Line 2 and Line 3) —
Power connection to transfer switch.
E ‑ Neutral and/or Ground Connection — Connect to
transfer switch neutral and ground
Series 60000* Voltage Rated Amps Wire Size
3 Phase Wye
120/208 215 250 kcmil
3 Phase Wye
139/240 186 4/0
3 Phase Delta 120/240 186 4/0
3 Phase Wye 240/416 108 1 AWG
3 Phase Wye
277/480 93 2 AWG
3 Phase Wye
346/600 73 4 AWG
*Refer to Generator Data Tag to determine series of generator.
A
B
C
D
D
C
NOT
for
REPRODUCTION