Gamewell Honeywell GWF-7075, Руководство пользователя

Страница: 26 / 100

26
GWF-7075 Manual —
LS10147-002GF-E:G 10/5/2022
Control Panel Installation RA-1000/R Remote Annunciator Installation
The RA-1000/R comes from the factory fully assembled. You must disassemble it for mounting. To disassemble the annunciator, use a 5/64
hex wrench to remove the set screws, located on the bottom of the annunciator bezel. (See Figure 4.11 for location of the set screws.)
Flush Mounting
This section of the manual describes flush mounting. You can flush-mount with or without an electrical box.

Flush Mounting with an Electrical Box
The RA-1000/R annunciator can be used with the following types of electrical boxes: 4S, single-gang, and double-gang.
If an electrical box is used, the box must be 1-3/8” back from the face of the wall to accommodate the annunciator. Studs used with an elec-
trical box must be 2x4” (or larger).

Flush Mounting Steps
1. Cut a hole in the sheet rock to the following dimensions: 8-1/4” W x 6-5/8”H. If an electrical box is used, the box must be 1-3/8” back
from face of wall to accommodate the annunciator.
2. Remove knockout holes as needed for wires.
3. Fit the annunciator backbox into the hole and stabilize with mounting wires. Angle the mounting wires into the first hole past the sheet
rock. Secure the wires behind the screws as shown in Figure 4.12. When all four wires are in place, the backbox should fit snugly into
the hole in the sheetrock.
4. After the annunciator wiring to the panel has been completed (refer to Figure 4.7), replace the electronic assembly in the back box.
Place the bezel over the back box and tighten the set screws on the bezel.
Surface Mounting
The RA-1000/R can be mounted directly to a surface or can be attached to a single, double, or four-square electrical box. Trim Ring Kit
5860TR/Gis available for use when surface mounting.
1. Drill holes in the surface to match the screw holes on the backbox. Refer to Figure 4.11 for locations.
2. Fit the trim ring over the backbox.
3. Attach the backbox to the wall using screws provided.
knockouts
screws for placement
of mounting wires
Set Screw
holes for inserting wires
for flush-mounting
(located in all corners)
surface mounting holes
knockouts
Figure 4.11 Annunciator Backbox and Bezel Details
Attach second set of wires to top of backbox.
Secure wires behind screw.
Insert wires at an angle into the first holes past sheetrock.
Figure 4.12 Flush Mounting the Backbox