Galcon GalStar, Инструкция, Страница: 24 / 107

24
GalStar
Instruction 1.0
3. Basic Operation
• Water Required:
Programmable parameter. Enter the amount according to the water unit selected.
• Water Unit:
Information only (see program constants).
• Fertilizing Program:
(Programmable) the programming of fertilizer is via the “fertilizer
programs” which are assigned to the “Irrigation Programs” in this section.
o
Fert. Program Number:
Enter the number of the required fertilizer program.
o
Water Before:
The amount of irrigation according to the water unit delivered before the
fertilizer pump starts working. It is used in order to stabilize pressure before fertilizing starts.
o
Water After:
The amount of irrigation according to the water unit delivered after the
fertilizer pump starts working. It is used for flushing the fertilizer from the pipelines.
o
Fert. Failure Action (continue/stop):
The action to be taken in the case of
fertilizer failure.
* Press “Page Down” to scroll down to see the rest of the screen.
• Current Timing:
(these parameters are for both information and programming). Current
timing shows the next program start time. The time shown here is the time the irrigation will
start regardless of other calculations. These parameters can be manually altered. They can
be used in order to program the next irrigation time even if the “program timing” (fixed cyclic
program) is not programmed. Program one-time irrigation here (do not forget to program the
number of cycles) and check the data here before leaving the controller for several hours in
order to make sure that everything is okay.
o
Next Cycle Time:
The time the next cycle starts.
o
Next Irrigation Day:
0 = today, 1 = tomorrow, 2 = the day after tomorrow etc.
o
Cycles Remaining:
The number of cycles to be carried out in the next irrigation
program (when the program is running it shows the number of cycles left.